view · edit · print · history

(redirected from NAS200.Bootlog)

+Ethernet eth0: MAC address 00:18:39:a7:92:f2
IP:, Gateway:
Default server:

RedBoot(tm) bootstrap and debug environment [ROM]
Non-certified release, version v2_0 - built 16:52:38, Nov 30 2006

Platform: PC (I386) 
Copyright (C) 2000, 2001, 2002, Red Hat, Inc.

RAM: 0x00000000-0x000f0000, 0x000720b0-0x000a0000 available
R3210    00:0012 11-01-2006
<press Ctrl+C to enter prompt mode>

mem_size: 2000000
initrd 1a00000 len 600000
Linux version 2.6.19 (shearer@Shearer-X60) (gcc version 3.3.4) #84 Thu May 10 23:57:03 CST 2007
BIOS-provided physical RAM map:
 BIOS-e801: 0000000000000000 - 000000000009f000 (usable)
 BIOS-e801: 0000000000100000 - 0000000002000000 (usable)
0MB HIGHMEM available.
32MB LOWMEM available.
Zone PFN ranges:
  DMA             0 ->     4096
  Normal       4096 ->     8192
  HighMem      8192 ->     8192
early_node_map[1] active PFN ranges
    0:        0 ->     8192
DMI not present or invalid.
ACPI: Unable to locate RSDP
Allocating PCI resources starting at 10000000 (gap: 02000000:fe000000)
Built 1 zonelists.  Total pages: 8128
Kernel command line: console=ttyS0,38400 root=/dev/mtdblock1
Initializing CPU#0
PID hash table entries: 128 (order: 7, 512 bytes)
Console: colour dummy device 80x25
Dentry cache hash table entries: 4096 (order: 2, 16384 bytes)
Inode-cache hash table entries: 2048 (order: 1, 8192 bytes)
Memory: 22336k/32768k available (2218k kernel code, 10044k reserved, 905k data, 156k init, 0k highmem)
virtual kernel memory layout:
    fixmap  : 0xfffea000 - 0xfffff000   (  84 kB)
    pkmap   : 0xff800000 - 0xffc00000   (4096 kB)
    vmalloc : 0xc2800000 - 0xff7fe000   ( 975 MB)
    lowmem  : 0xc0000000 - 0xc2000000   (  32 MB)
      .init : 0xc0410000 - 0xc0437000   ( 156 kB)
      .data : 0xc032a851 - 0xc040cfc8   ( 905 kB)
      .text : 0xc0100000 - 0xc032a851   (2218 kB)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Mount-cache hash table entries: 512
Compat vDSO mapped to ffffe000.
CPU: 486
Checking 'hlt' instruction... OK.
checking if image is initramfs...it isn't (bad gzip magic numbers); looks like an initrd
Freeing initrd memory: 6144k freed
NET: Registered protocol family 16
PCI: Using configuration type 1
Setting up standard PCI resources
ACPI: Interpreter disabled.
SCSI subsystem initialized
usbcore: registered new interface driver usbfs
usbcore: registered new interface driver hub
usbcore: registered new device driver usb
PCI: Probing PCI hardware
NET: Registered protocol family 2
IP route cache hash table entries: 256 (order: -2, 1024 bytes)
TCP established hash table entries: 1024 (order: 2, 16384 bytes)
TCP bind hash table entries: 512 (order: 1, 10240 bytes)
TCP: Hash tables configured (established 1024 bind 512)
TCP reno registered
audit: initializing netlink socket (disabled)
audit(1249617731.930:1): initialized
Total HugeTLB memory allocated, 0
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
squashfs: version 3.0 (2006/03/15) Phillip Lougher
NTFS driver 2.1.27 [Flags: R/O].
SGI XFS with large block numbers, no debug enabled
SGI XFS Quota Management subsystem
io scheduler noop registered
io scheduler anticipatory registered (default)
io scheduler deadline registered
io scheduler cfq registered
pci_hotplug: PCI Hot Plug PCI Core version: 0.5
Serial: 8250/16550 driver $Revision: $ 4 ports, IRQ sharing enabled
?serial8250: ttyS0 at I/O 0x3f8 (irq = 4) is a 16550A
RAMDISK driver initialized: 8 RAM disks of 8192K size 1024 blocksize
r6040: RDC R6040 net driver, version 0.9 (12July2005)
r6040: RDC R6040 net driver, version 0.9 (12July2005)
r6040: RDC R6040 net driver, version 0.9 (12July2005)
PCI: Enabling device 0000:00:04.0 (0005 -> 0007)
sata_sil 0000:00:04.0: cache line size not set.  Driver may not function
sata_sil 0000:00:04.0: Applying R_ERR on DMA activate FIS errata fix
ata1: SATA max UDMA/100 cmd 0xC2800080 ctl 0xC280008A bmdma 0xC2800000 irq 9
ata2: SATA max UDMA/100 cmd 0xC28000C0 ctl 0xC28000CA bmdma 0xC2800008 irq 9
scsi0 : sata_sil
ata1: SATA link down (SStatus 0 SControl 310)
scsi1 : sata_sil
ata2: SATA link down (SStatus 0 SControl 310)
physmap flash device: 800000 at ff800000
phys_mapped_flash: Found 1 x16 devices at 0x0 in 16-bit bank
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
 Intel/Sharp Extended Query Table at 0x010A
Using buffer write method
cfi_cmdset_0001: Erase suspend on write enabled
cmdlinepart partition parsing not available
RedBoot partition parsing not available
Using physmap partition definition
Creating 4 MTD partitions on "phys_mapped_flash":
0x00000000-0x001c0000 : "Kernel"
0x001c0000-0x007c0000 : "Initrd"
0x007c0000-0x007e0000 : "Config"
0x007e0000-0x00800000 : "Redboot"
ehci_hcd 0000:00:0a.1: EHCI Host Controller
ehci_hcd 0000:00:0a.1: new USB bus registered, assigned bus number 1
ehci_hcd 0000:00:0a.1: irq 14, io mem 0xc1000000
ehci_hcd 0000:00:0a.1: USB 2.0 started, EHCI 1.00, driver 10 Dec 2004
usb usb1: configuration #1 chosen from 1 choice
hub 1-0:1.0: USB hub found
hub 1-0:1.0: 2 ports detected
ohci_hcd 0000:00:0a.0: OHCI Host Controller
ohci_hcd 0000:00:0a.0: new USB bus registered, assigned bus number 2
ohci_hcd 0000:00:0a.0: irq 15, io mem 0xc1001000
usb usb2: configuration #1 chosen from 1 choice
hub 2-0:1.0: USB hub found
hub 2-0:1.0: 2 ports detected
USB Universal Host Controller Interface driver v3.0
Initializing USB Mass Storage driver...
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
mice: PS/2 mouse device common for all mice
i2c /dev entries driver
In i2c_add_driver(), will call i2c_register_driver
Call driver_register().
After driver_register().
i2c-velleman.o: i2c Velleman K8000 adapter module version 2.6.1 (20010830)
3530A: I2C based RTC driver for S-3530A.
In i2c_add_driver(), will call i2c_register_driver
Call driver_register().
After driver_register().
Call i2c_attach_client().
md: raid0 personality registered for level 0
md: raid1 personality registered for level 1
md: multipath personality registered for level -4
device-mapper: ioctl: 4.10.0-ioctl (2006-09-14) initialised: dm-devel@redhat.com
TCP cubic registered
NET: Registered protocol family 1
NET: Registered protocol family 17
Using IPI Shortcut mode
md: Autodetecting RAID arrays.
Time: pit clocksource has been installed.
md: autorun ...
md: ... autorun DONE.
RAMDISK: Couldn't find valid RAM disk image starting at 0.
VFS: Mounted root (squashfs filesystem) readonly.
Freeing unused kernel memory: 156k freed
Creating ramfs for /var/
Loading Modules:
Using /lib/pbuttons.ko
pbuttons: module license 'unspecified' taints kernel.
Using /lib/nls_cp932.ko
Using /lib/nls_cp949.ko
Using /lib/nls_cp950.ko
Fan is on.
Creating ramfs for /tmp:
Starting Set CGI_ds.conf:
route: SIOC[ADD|DEL]RT: File exists
0 0 0 0 :0 0 0 0
Restore time and timezone:
Restore usrgrpshares:
Starting WEB Server:
Starting samba:
Starting download:
download uses obsolete (PF_INET,SOCK_PACKET)
device eth0 entered promiscuous mode
audit(1186224266.109:2): dev=eth0 prom=256 old_prom=0 auid=4294967295
Starting INET Server:
Starting QuickSet Daemon :
Starting Rest Task :
Boot Complete!
Checking disk status :

Please press Enter to activate this console. 

BusyBox v1.00-rc2 (2007.05.24-02:02+0000) Built-in shell (ash)
Enter 'help' for a list of built-in commands.

$ cat /proc/cpuinfo
processor       : 0
vendor_id       : unknown
cpu family      : 4
model           : 0
model name      : 486
stepping        : unknown
fdiv_bug        : no
hlt_bug         : no
f00f_bug        : no
coma_bug        : no
fpu             : no
fpu_exception   : no
cpuid level     : -1
wp              : yes
flags           :
bogomips        : 49.76

$ $ cat /proc/meminfo
MemTotal:        28636 kB
MemFree:          2004 kB
Buffers:          2632 kB
Cached:          15304 kB
SwapCached:          0 kB
Active:          10796 kB
Inactive:        11940 kB
HighTotal:           0 kB
HighFree:            0 kB
LowTotal:        28636 kB
LowFree:          2004 kB
SwapTotal:           0 kB
SwapFree:            0 kB
Dirty:               0 kB
Writeback:           0 kB
AnonPages:        4828 kB
Mapped:           2380 kB
Slab:             3028 kB
SReclaimable:     1056 kB
SUnreclaim:       1972 kB
PageTables:        380 kB
NFS_Unstable:        0 kB
Bounce:              0 kB
CommitLimit:     14316 kB
Committed_AS:    22760 kB
VmallocTotal:   999416 kB
VmallocUsed:      8576 kB
VmallocChunk:   990448 kB
HugePages_Total:     0
HugePages_Free:      0
HugePages_Rsvd:      0
Hugepagesize:     4096 kB
$ cat /proc/mtd 
dev:    size   erasesize  name
mtd0: 001c0000 00020000 "Kernel"
mtd1: 00600000 00020000 "Initrd"
mtd2: 00020000 00020000 "Config"
mtd3: 00020000 00020000 "Redboot"

view · edit · print · history · Last edited by dyoung.
Originally by dyoung.
Page last modified on August 05, 2007, at 11:03 PM